Doubt

RedR · Post by **RedR** » Wed May 17, 2006 11:19 am

I?m running the s300 on my car, but from time to time it seems the software forgets the defined target lambda and goes back to its original values, is this a bug or something?

Post by **Spunkster** » Wed May 17, 2006 11:39 am

Can you be more specific and post calibrations and datalogs?

RedR · Post by **RedR** » Wed May 17, 2006 8:27 pm

for example i set target lambda to 14.7 low load, 13.2 medium load and 11.8 high load, and after loading the map a few times it goes back to the pre defined values ( 14.7 / 13.5 / 12.5 )

Post by **Hondata** » Thu May 18, 2006 2:05 pm

Can you give a sequence of operations which will reset the values?

RedR · Post by **RedR** » Thu May 18, 2006 8:35 pm

it happens after i start the s300 manager a couple of times and load the map im tuning, lately havent had any issues though (not that i can call that an issue)