Factory settings

cukali · Post by **cukali** » Thu Apr 27, 2006 10:57 am

Can one get a copy of the factory settings?

Also, I was under the impression factory fuel cut off was above redline... around 7000-7200. Can someone clarify?

I have three dyno runs that go to 7200. Is this accurate?

thnx

Post by **Spunkster** » Thu Apr 27, 2006 1:47 pm

You have not provided enough information to give any type of answer.

Stock calibrations can be found in the software by going to File, New.

cukali · Post by **cukali** » Fri Apr 28, 2006 5:47 am

Well I certainly left no info. I guess I was going to fast.....

K20A3 factory cutoff?
EP3 Factory maps?

thnx again.

Post by **Hondata** » Fri Apr 28, 2006 8:49 am

Factory rev limiter for the K20A3 is 6900 rpm. The stock tach is not accurate. The factory calibration is available under File, New...