8th gen FBO hybrid racing, 3” thermal r&d and plm headers

[mrspades252]

I know Ill have to get it tuned eventually but I was wondering to see if anybody has a calibration or something similar?

[CalibratEd]

Run a Hondata base calibration with the mods closes to yours until you can get it tuned. I can check how it’s running if you post the calibration and a datalog.

-Ed

[mrspades252]

Will do ASAP, i actually took my suspension apart and will be installing coilovers! Thanks!

[CalibratEd]

Will do ASAP, i actually took my suspension apart and will be installing coilovers! Thanks!

No problem. Sounds good.

-Ed

[mrspades252]

Will do ASAP, i actually took my suspension apart and will be installing coilovers! Thanks!

No problem. Sounds good.

-Ed

Alright Ed, i ran into a lot of issues over the past few weeks with this car since i posted. Old suspension were seized, and had idle/drivability issues, which prevented me from replying back! I finally got the coilovers installed and fixed the idle/drivability issues (replaced maf sensor)! I will start datalogging on saturday but am unsure on which calibration to use! Will you still be able to give me a hand?

[CalibratEd]

Sorry to hear that. Like I said prior, select a file with mods closes to yours and I can let you know how it’s running.

-Ed

[mrspades252]

How should i datalog? Locally and on the freeway?

[CalibratEd]

How should i datalog? Locally and on the freeway?

Both are fine. Just refrain from doing any wide open throttle pulls.

-Ed

[mrspades252]

this is the calibration i used

here is a datalog!

[mrspades252]

heres another datalog

[CalibratEd]

The fueling is not far off and you do not have any knock.

- Ed

[mrspades252]

Awesome so i should be able to drive it around for the time being until i can get it dyno tuned?

[CalibratEd]

Yes.

-Ed