FlashProManager 4.4.9

[Hondata]

FlashProManager 4.4.9 (15 May 2025)

• Firmware updated to version 262
• Fixed TSX/RDX not detecting ECU

Download here

[bestlap]

just found out some of my preview mapping cannot upload because the software changed calibration from US to middle east , or from japan to Middle east also, i try to change the location and upload but the mapping crash, car doesn't run good,please check

thanks
KL

[bestlap]

updated 4.5.0.0

Open the file was tuned with US, now auto changed to Middle east same as 4.4.9, i change location to US and save it, reopen now it is Japan.

please check again thank you!
KL

[Hondata]

You'll have to tell me what vehicle model you have, if you are doing this with the flashpro plugged into the laptop, and what the calibration is (post it here).

[bestlap]

This is the map start tune with US FL5 and now calibration auto changed to Japan
no flashpro plug in, just open from my files

[Hondata]

Seems fine for me. Can you run through step by step what you are doing and where it goes wrong?

[bestlap]

like this map it is Japan FL5 was saved and using long time, now we open it and auto changed the location to middle east

[Hondata]

That calibration was saved as a Middle East model. Change to US, save and then it will show as US.