Looking for a review, k24a fa5

[Emilek24a]

Hi everyone, just swapped a k24a rbb engine in my 2011 fa5, mods are: 50degrer vtc, plm headers,hybrid racing cold air intake,rbc intake manifold. Everything else is stock. Runs good on a basemap I found here, just wanted to make sure everything is fine to drive as is, until I get it proprely tuned. From my understanding, injectors seems maxed out near redline. Any help is appreciated thanks. In attachements is the basemap and im using and a log of normal driving with one wot 3rd gear pull.

[CalibratEd]

Welcome to the forum,

The car is running a little lean. The good thing is that I did not see any knock. Yes, the injectors are maxing out close to redline.

Also, keep in mind that the calibration you are running is a starter calibration locked at 0VTC. It should hold you over until you get tuned.

- Ed