Analog inputs to fuel table?

[KanoB20v]

Hello I'm am try to figure out if there is a way to get my analog inputs to display on fuel tables for fuel adjustments and what not. I have a AEM WIDEBAND 30-4110 . I wired it up to analog input 0 I got it pretty accurate reading to show on "display" but I would like it to show on the fuel table is there anyway to do so with it wired to analog input 0

[Spunkster]

It would be best to use the ECU inputs instead of the analog inputs on the s300 as then it can run closed loop and have full functionality.

[KanoB20v]

Could I get away with just taping the "white" 0-5 volt output from the wideband to the d14 pin or would i have to re wire both ground and power from the wideband to the ecu as well?

[Spunkster]

Power and ground do not matter. You should use D10 instead of D14 as it cannot read the full voltage range.

[KanoB20v]

How will using the d10 impact negatively or the side effects if you will? I just wanna understand before I got tapping in to wires

[Spunkster]

There are no side effects. Details can be found in the help file at: https://hondata.com/help/smanager/wideb ... b=wideband