Just to clarify, if I want to datalog oil pressure throughout a run can I wire the AEM oil pressure gauge to either B6 or D12?
From what I understand only the brown wire should be pinned to B6 or D12. Can someone confirm that?
I will also check to make sure the right capacitors are there.
Wiring AEM oil pressure gage to S300 V1
Wiring AEM oil pressure gage to S300 V1
You do not have the required permissions to view the files attached to this post.
Re: Wiring AEM oil pressure gage to S300 V1
You can, but it is for datalogging only and cannot be used for any protections.
Re: Wiring AEM oil pressure gage to S300 V1
Understood. Can you confirm the wiring is correct?
Re: Wiring AEM oil pressure gage to S300 V1
No, the white wire must be connected as it is the signal.
Re: Wiring AEM oil pressure gage to S300 V1
Brown to B2? Or does another ground work?
Re: Wiring AEM oil pressure gage to S300 V1
It may not need a signal ground. Try it without it and see if it reads correctly.