Clutch Switch, ground or positive

crucian · Post by **crucian** » Tue Mar 28, 2006 6:53 am

I have been looking all over on how to install the clutch switch for the S300. All I find is the installation for the S200 with an interface box. My questions is, do I run ground through the clutch switch to ECU, or do I run a 12v wire? Can't seem to find that answer no where. Thanks!

Post by **Hondata** » Tue Mar 28, 2006 9:04 am

You need to look at the input used in SManager, and then refer to the manual to see how it is normally wired. eg if you use the PSP input, then this switch goes to ground to activate it.

crucian · Post by **crucian** » Tue Mar 28, 2006 9:42 am

Thanks for the quick response!