S300 I Analog Inputs
S300 I Analog Inputs
Was the analog input (0-5 VDC) setup removed from the software for s300 I? I recently downloaded the software from the website and found that the Analog Input tab is greyed out and states, "V2 and V3 only".
You do not have the required permissions to view the files attached to this post.
Re: S300 I Analog Inputs
Nothing was changed. The legacy Analog1 and Analog2 are still there.
Hondata
Re: S300 I Analog Inputs
I figured this out. I will post the steps below to access these settings because it's not easily found in the Help Contents.
1. Access the Analog Input conversion table:
Options -> Settings 2. Rename sensor through Sensor Setup:
Sensors tab -> scroll down to Analog1/Analog2 -> right click (or double click) -> Properties
1. Access the Analog Input conversion table:
Options -> Settings 2. Rename sensor through Sensor Setup:
Sensors tab -> scroll down to Analog1/Analog2 -> right click (or double click) -> Properties
You do not have the required permissions to view the files attached to this post.