ep3 basemap

[Mgs41987]

hi, i just got a kpro v4, does anyone have a base file for the following mods

skunk 2 style inlet
k&n typhoon
custome 2.75 inch exhaust which was from a previous car that achieved 242 on dyno
421 toyosports manifold

just learning at the moment and new to honda world, i would get it rolling road but nearest one that's reputable is 200 miles away, but waiting to get camshafts and bigger injectors

thanks in advance, i dont mind paying

[CalibratEd]

Look for a base calibration with mods closes to yours. Try to make it run safe. Some of the work will have to be redone when to install the cams and injectors. Are you running the stock engine?

-Ed

[Mgs41987]

Hi yes running a stock engine other then bolt on mods. I have loaded a base map on there. Smells a bit lean in higher rpm, no smoke though in vtec or across rev range apart from a little puff here and there. Also smells a bit rich on lower rpm but it's decatted so maybe a red herring

[CalibratEd]

Post the calibration and a datalog. I can take a look at it and let you know how it’s running.

-Ed

[Mgs41987]

file and datalog.zip

hi bud, its a 3rd gear run, starting at 2k rpm to near redline, there are 2 runs both sort of the same just one i changed up gear at one point

[CalibratEd]

I looked over the log and there is no wideband reading. I assume you are running a PRA ECU. You would need to connect a wideband to the kpro board. This would help assess your fueling.

- Ed

[Mgs41987]

I will look into fitting one thankyou

[CalibratEd]

Sounds good.

-Ed