Turbo K24a1 Troubleshooting Issue(Part Throttle Subbie Stutter)

K-Series Programmable ECU Calibration updates / downloads
Post Reply
playap07
Posts: 2
Joined: Wed Jul 18, 2018 11:52 am

Turbo K24a1 Troubleshooting Issue(Part Throttle Subbie Stutter)

Post by playap07 »

Good evening Hondata forum,

I've been having some issues driving my 05 Civic SI with a turboed K24a1. The car is tuned but had minor knock issues in the past under part throttle. I moved from North Carolina to Las Vegas and then the car gradually started acting up. It's miserable to drive around normally but under full throttle it doesn't seem to have any symptoms. I have attached datalogs if someone could see any issues to guide me on what the issues could be. The car stutters under part throttle, it sounds like a subbie until I increase the throttle.

What I've tried to solve issue:
I replaced sparks - no change
Was about to replace Vtec solenoid but didn't due to full throttle pull working with no issues.
Tried 100 octane fuel to see if it was because my car was tuned on 93 octane but West coast has 91 normally - no change (Car is supposed to have a conservative tune to cope with this)
Seafoamed oil, fuel and brake booster - No change

Please advise on what I should look into to solve this issue.

V/r
Pat
You do not have the required permissions to view the files attached to this post.
User avatar
CalibratEd
Posts: 1674
Joined: Fri Feb 07, 2020 3:20 pm
Contact:

Re: Turbo K24a1 Troubleshooting Issue(Part Throttle Subbie Stutter)

Post by CalibratEd »

Pat,

Welcome to the forum. Post the calibration file you are running and I can look it over along with the datalogs.

- Ed
Instagram: calibrated.tuning
playap07
Posts: 2
Joined: Wed Jul 18, 2018 11:52 am

Re: Turbo K24a1 Troubleshooting Issue(Part Throttle Subbie Stutter)

Post by playap07 »

Thanks Ed. Sorry for the late response. Figured out it was the TPS. My TPS sensor was bad so it was making the car act all weird until full throttle was recognized. Corrected the issue now with a new acuity TPS and added a new Skunk2 intake manifold. Thanks for the interest in helping! Cheers!

V/r
Pat
You do not have the required permissions to view the files attached to this post.
User avatar
CalibratEd
Posts: 1674
Joined: Fri Feb 07, 2020 3:20 pm
Contact:

Re: Turbo K24a1 Troubleshooting Issue(Part Throttle Subbie Stutter)

Post by CalibratEd »

No problem. I’m glad you figured it out.

-Ed
Instagram: calibrated.tuning
Post Reply