05/06 RSX with k20a2

[Kreetoes]

Get crank but no start. I NEED HELP YALL

[Spunkster]

Is the immobilizer enabled or disabled in the calibration?

[Kreetoes]

Immobilizer is disabled.
For more context, I hade the 05 base harness with the new engine in and still had the same problem. Car started with the base ecu but no the kpro. I was then told to switch to the engine harness for the actual engine. Here I am no with the same problem of getting a crank with no start. I have all the right sensors and modified the harness to what needed to be modified. Could it just be that i have the wrong settings on my kpro?

[Kreetoes]

NOTE: I have the conversion harness for the kpro

[Spunkster]

What is the serial number that is on the K-Pro bard inside the ECU?

From Help, About, what is the version of software you are using?

[Kreetoes]

Serial Number on ECU is 37820-PND-AO5

Software Version 4.5.9.0

[Spunkster]

I need the serial number on the K-Pro board inside the ECU.

[Kreetoes]

IMG_4298.jpeg

[Spunkster]

According to our records this K-Pro was not modified for use with an 05-06 RSX and was not sold with an adapter harness.

[Kreetoes]

Should I contact to send it over to get it modified and would I need a new conversion harness?

[Kreetoes]

Also is there a copy of the initial form that i sent when ordering the kpro. If this is case, how come I was able to run the K-pro when i had my K20A3 still in the vehicle.

[Spunkster]

Where did you get the adapter harness?

Post a picture of it.

[Kreetoes]

My coworker had one. Figured it would save me money since he had no use for it anymore.

[Spunkster]

That will not work properly as the ECU was not modified for use in an 05-06 RSX.

The form you need to use to get the ECU modified and purchase the adapter harness can be found at: http://hondata.com/downloads/05-06_rsx_ ... e_form.pdf

[Kreetoes]

Okay thank you for your help!