Adding some extra Data .. From the last car happening.
Please check the datalog .. First 10 sec the map is stuck. We took ou the connector, plug it again.. Re-fire the engine .. And the reading back to OK.
MAP Channel stuck
-
terrorista
- Posts: 38
- Joined: Sat Jan 23, 2016 3:17 am
Re: MAP Channel stuck
Please check the datalog .. First 10 sec the map is stuck. We took ou the connector, plug it again.. Re-fire the engine .. And the reading back to OK.
You do not have the required permissions to view the files attached to this post.
Re: MAP Channel stuck
calibration is locked
-
terrorista
- Posts: 38
- Joined: Sat Jan 23, 2016 3:17 am
Re: MAP Channel stuck
My Bad ... Attached Unlocked ...
You do not have the required permissions to view the files attached to this post.
Re: MAP Channel stuck
How exactly are the boost control and wideband wired.
-
terrorista
- Posts: 38
- Joined: Sat Jan 23, 2016 3:17 am
Re: MAP Channel stuck
WBO with Analog channel direct to pin ...
BC have a fuse before entering B2, other terminal have a tic-tac switch to turn boost on and off aside the VSA switch, the ground used for it is from the body.
Re: MAP Channel stuck
If these are all removed, does the same issue persist?
-
terrorista
- Posts: 38
- Joined: Sat Jan 23, 2016 3:17 am
Re: MAP Channel stuck
Let me try that ...
The only strange thing is that this "lock" happens in other cars too.
The only strange thing is that this "lock" happens in other cars too.
-
terrorista
- Posts: 38
- Joined: Sat Jan 23, 2016 3:17 am
Re: MAP Channel stuck
Just Removed the wires ... Same Issue ... Just happens with 4bar map sensors. With OEM Map .. Nothing happens.
Attached the starting datalog wth cut wires.
You do not have the required permissions to view the files attached to this post.
-
terrorista
- Posts: 38
- Joined: Sat Jan 23, 2016 3:17 am
Re: MAP Channel stuck
What else can we test spunkster? Thanks
Re: MAP Channel stuck
I tested this in our 06 Si and it reads the 4bar as it should. I suspect there is some other cause on these vehicles.