8th Gen Civic Si k24a base tune.

[DuPree96]

Hello. I am new to Hondata and I was wondering if anyone would be able to help me with a base calibration on my setup to test drive the car?

My setup is a K24a 3 lobe, Skunk 2 headers, RBC intake gear (pinned at 40°) and a Hybrid racing intake.

I managed to get the car running on a k20z3 base tune but I can't find one for a K24a on an 8th gen.

Thank you everyone.

[DuPree96]

Apologies, I didn't list my whole setup above.

I am running an RBC intake and full 8th gen si accessories.

[CalibratEd]

Hello. I am new to Hondata and I was wondering if anyone would be able to help me with a base calibration on my setup to test drive the car?

My setup is a K24a 3 lobe, Skunk 2 headers, RBC intake gear (pinned at 40°) and a Hybrid racing intake.

I managed to get the car running on a k20z3 base tune but I can't find one for a K24a on an 8th gen.

Thank you everyone.

Welcome to the forum,

If you got it running with the k20z3 base calibration dial in fuel and timing to make it runs safe until you can get properly tuned. There might be a base calibration floating in the forum for a k24 swapped 8thgen but on the stock VTC.

When you decide what calibration you want to run, post the calibration and a datalog. I can look them over to make sure the car is running safe.

- Ed

[DuPree96]

Awesome, I'll try and get that done this evening! Thank you so much.

[CalibratEd]

No problem.

-Ed

[DuPree96]

Here are two datalogs I just took, thanks again for the help.

[CalibratEd]

Post the calibration as well.

-Ed

[DuPree96]

Sorry about that!