Check my datalog

[Saturo.fk8]

Hey guys,

delete if not allowed.

Can someone please check my datalog to make sure that everything is running smooth after i uploaded a basemap on my fk8?
i let the car warmup then did a few pulls on the motorway.

TIA

[Bravo]

I'm no expert but from what I can tell everything looks mostly safe & fine... although your "highway pulls" start pretty late and end very early (only revving out to 5500 rpm max), so it's impossible to tell beyond that. Also, rather change the datalog rate to ""fast" on your flashpro to get more data points and increase the resolution of the datalog...

Try perform a couple pulls from 2500 rpm in 3rd gear until redline (foot flat to the floor not half throttle).
NB: Make sure you have a clear, straight, empty road ahead of you before attempting this.

Although your AF is spot on, your AFM.v vs S.TRIM reading is about 5% low which could indicate your AFM possibly needs calibration.
Do you have any modifications to the car? What fuel you running... 91, 93, with 10% ethanol or not?

[Saturo.fk8]

Hey Bravo,

I’ll do another datalog and do pulls when the weather is a little bit better.

Bolt ons I have on the car
Prl street maf intake
Prl titanium inlet pipe
Prl intercooler + the charge pipe

No ethanol and im on 91 octane which is equivalent to 95ron here in New Zealand