Analog inputs not working after firmware V2.8.4

[kseriescivic]

Opened hondata after updating to V2.8.4 firmware Dec 5th update and none of my analog input sensors are reading on the display tab or during datalogging.

Is there something I’m missing or need to do to get them to work?

[Spunkster]

With everything plugged in and the ignition in the on position, go to the Help menu and click on “send feedback”. Include a detailed description of the issue.

[bradheller29]

Also having this issue. I did "send feedback" hoping it gets resolved. Thanks.

[kseriescivic]

Okay I was wondering if anyone else was having this issue. Same, hopefully it gets resolved!

[Jnguyen]

Having save issue, no readings on analogs. When does Hondata usually update firmware again ?

[Hondata]

Please can you tell us what S300 you have. The best way would be in the S300 window, S300 tab under hardware, the hardware version and processor type. There are 6 different hardware types so knowing this will cut down the amount of time it takes to fix this.

Also it would be good to know how the analog input has been configured, and what type of datalogging you are doing.

[kseriescivic]

Here’s what it says under about. I’ll have to connect to the ecu tomorrow to look under the s300 tab.

[Jnguyen]

Please can you tell us what S300 you have. The best way would be in the S300 window, S300 tab under hardware, the hardware version and processor type. There are 6 different hardware types so knowing this will cut down the amount of time it takes to fix this.

Also it would be good to know how the analog input has been configured, and what type of datalogging you are doing.

trying to data log oil pressure and fuel pressure, analog 1 and 2. getting voltage signal to s300 v3 but not reading on display.

[DaX]

I'm sure you guys are on it, but I'll also mention that I'm having this issue as well. S300V3, wired in a pressure sensor, sending to analog 1. I verified correct wiring and scaling, I am getting the correct voltage out of the sensor, but am not getting anything to show on the display or on the sensors tab.

[Jnguyen]

I'm sure you guys are on it, but I'll also mention that I'm having this issue as well. S300V3, wired in a pressure sensor, sending to analog 1. I verified correct wiring and scaling, I am getting the correct voltage out of the sensor, but am not getting anything to show on the display or on the sensors tab.

Same here I get “0” values

[Hondata]

Please, please tell us what hardware you have as outlined above. And provide a calibration if you can.

[Jnguyen]

Please can you tell us what S300 you have. The best way would be in the S300 window, S300 tab under hardware, the hardware version and processor type. There are 6 different hardware types so knowing this will cut down the amount of time it takes to fix this.

Also it would be good to know how the analog input has been configured, and what type of datalogging you are doing.

Here’s my hardware and processor

[Spunkster]

This should be fixed in a release of software tomorrow.

[Jnguyen]

This should be fixed in a release of software tomorrow.

when will this new firmware be ready?

[kseriescivic]

Not sure if you still need this but here’s my hardware and processor