Need help with proper tune 06 Si

[JT-06-si]

I'd like to be able to drive normal and WOT once in awhile.

I currently have FBO:

K&N SRI v2,
1320 performance headers (...),
Invidia Q300 exhaust.

Currently running on

Hybrid(Vtec4600).fpcal

Datalog:

datalog0000.fpdl

[JT-06-si]

I switched over to this cal and enabled AFM with Use speed/density with Minimum pressure at 70.03 kPa.

[JT-06-si]

Here is another datalog that recorded 3 total knocks in KCount2 and KCount3.

Is my tune going to kill my engine?

datalog0005.fpdl

[CalibratEd]

I suggest you reduce the timing in the area you see knock. I also suggest you add fuel in the higher RPMS. Its running a bit leaner than I would run.

The lower ends is running fine as its using he MAF sensor and dialed in well.

- Ed