mikelowrie86 wrote: Tue Dec 05, 2023 8:40 pm
Thanks Ed, Im doing general maint right now on the car so ill put your new trim on. I appreciate you helping. I noticed the knock was down a lot more on this log. Have a good night ill post tomorrow with new log.
The car only had 1 count of knock. I adjusted the timing a bit more. No more logs are needed. You should be good to normal drive the car. Reach out when you're ready for a full tune.
- Ed
You do not have the required permissions to view the files attached to this post.
Thanks Ed, Ive had this car since I first joined the army in 2004 so I really appreciate the help. I gotta drive to apple valley tomorrow for a appointment so I will take a log for my learning. I am most definitely ready for more aggressive building if your willing. My compression numbers are still in the 190's even with over 200k miles. Let me know if you want to know more about the car and what not.
Good evening I saw on the hondata page you were helping out other fellow mates with safe base maps on there 8th Gen Si’s. I was hoping you could help me out on setting up a safe base map for my 8th Gen Si k24a swapped with skunk2 mega power headers , full race 3” exhaust, rbc manifold w/short ram intake until I go for a full tune. I set up a base map from videos I saw on YouTube but I’m just a little worried on Air fuel ratio and the whole fuel tuning aspect of it. I was hoping you can give me a hand and how much do you normally charge for help to get going. Right now I haven’t uploading the hondata map yet just cuz I don’t want to run lean or rich and risk blowing anything. Any help is appreciated thanks in advance!! I tried to email you not sure if it went through but my email is n.medrano09@yahoo.com
CholoFa5K24a wrote: Wed Dec 20, 2023 1:55 pm
Good evening I saw on the hondata page you were helping out other fellow mates with safe base maps on there 8th Gen Si’s. I was hoping you could help me out on setting up a safe base map for my 8th Gen Si k24a swapped with skunk2 mega power headers , full race 3” exhaust, rbc manifold w/short ram intake until I go for a full tune. I set up a base map from videos I saw on YouTube but I’m just a little worried on Air fuel ratio and the whole fuel tuning aspect of it. I was hoping you can give me a hand and how much do you normally charge for help to get going. Right now I haven’t uploading the hondata map yet just cuz I don’t want to run lean or rich and risk blowing anything. Any help is appreciated thanks in advance!! I tried to email you not sure if it went through but my email is n.medrano09@yahoo.com
