VSS+CSS

[ceruttibuilt]

hi i have a question about bout my vss setup

91 civic sedan k24a ep3 transmission with gear driven speedo
98 dc2 guage cluster
ppa auto crv ecu with kpro V4

power and ground wired to speed sensor, and signal is wired directly to the guage cluster and works perfecly

is it possible for the ecu automatic ecu to see the gear driven speed sensor signal? I know its looking for a CSS signal at pin C15 which would determine the vehilce speed and output the speed to E25 (VSS OUT)

Is it possible to get a working vss singal into my ecu so it sees my speed?

im gonna try to use the VSS digital pin and wire it up and mess with the settings and see i i can get anything to happen.

i dont know if this has been done yet.

Thanks in advance for any insight!

[ceruttibuilt]

* UPDATE*
So I figured it out..
I have the KPro Digital VSS signal wire connected to pin A18 (VSS) along with a wire going directly to the speed signal wire into the gauge cluster.

I selected alternate VSS input on K manager and set it to 2700 pulses per KM and smoothing set to 1 and it’s within 1 mph of GPS speed compared to the ecu speed signal. I also don’t have a CEL so it was successful!