p1166 2002 crv MT rbb3 kpro v3 aem 300

[notsonerdy]

car setup:

2002 crv MT, rbb3, kpro v3, aem 300

after I swapped in the rbb3 / kpro v3 it threw me p1166, so it was suggested to get an aem 300 AF gauge

I wired the signal to analog 0 and changed the "conversion" in the analog tab to AEM -0300, in the wide band tab in the settings ( use analog 0), and disabled secondary on the closed loop tab as well as unchecking the immobilizer and secondary 02 in the 'misc' tab

I am still getting code p1166 and the dashboard on the laptop isn't reading any numbers while the gauge itself is reading a steady 14.7 at idle ( fluctuates when throttle is engaged)


ive read on here that a p1166 code means the ecu is bad, is this true

[Spunkster]

Are you trying to run closed loop from an aftermarket wideband?

[notsonerdy]

im trying to just make it work

I plan on this being a stock swap, nothing special

[Spunkster]

You have a V3 K-Pro and it cannot use an external wideband for closed loop. That can only be done with the v4 K-Pro.

[notsonerdy]

I dont have that function requested - under that tab I have disabled ( open loop)


my issue is with the code... id happily take out the AEM o2 sensor and go back to stock if the p1166 would go away

this is my issue, any advice on how to remedy it would be appreciated

[rbb3crv]

Screenshot (5).png

[Spunkster]

Post your calibration

[rbb3crv]

how do i get there

[rbb3crv]

crv a2 map 1.kal

[rbb3crv]

is this what you are looking for

[Spunkster]

It sounds like either the factory wideband or the wiring for it has been damaged when installing other parts. I would follow the factory service manual for troubleshooting that error code.

[rbb3crv]

it worked fine before but it was damaged while the motor swap happened?

that doesnt make sense... im inclined to believe its a setting im missing here

i have 2 brand new 02 i'll fire in, lets see how they go

[rbb3crv]

Po134

Bank 1 no activity

[rbb3crv]

I put the original back in and it idled with out codes -texted for 5min

Still laptop program still doesn't have any a/f readings

[Spunkster]

Post the current calibration and a datalog showing what it is doing with the stock O2.