K24a2 with k20z4 head

MURPHITOJONES69 · Post by **MURPHITOJONES69** » Sat Jul 22, 2023 12:56 am

I'm having idle surging from 1.3k to 2.3k. Need assistance.

CalibratEd · Post by **CalibratEd** » Sat Jul 22, 2023 6:46 pm

MURPHITOJONES69 wrote: Sat Jul 22, 2023 12:56 am I'm having idle surging from 1.3k to 2.3k. Need assistance.

Have you checked for vacuum leaks?

-Ed

MURPHITOJONES69 · Post by **MURPHITOJONES69** » Sat Jul 22, 2023 7:41 pm

Yes I've checked for vacuum leaks, no vacuum leaks

CalibratEd · Post by **CalibratEd** » Sat Jul 22, 2023 9:11 pm

Post the calibration file and a datalog. I can take a look at it.

-Ed

MURPHITOJONES69 · Post by **MURPHITOJONES69** » Sat Jul 22, 2023 9:20 pm

I'll post it tomorrow morning. Thank you

MURPHITOJONES69 · Post by **MURPHITOJONES69** » Sat Jul 22, 2023 10:41 pm

I was able to perform the task

CalibratEd · Post by **CalibratEd** » Mon Jul 24, 2023 5:26 pm

Double check the IACV. It is throwing an error. It might not be connected and needs to be blocked off or it may have gone bad.
This can cause erratic idling.

-Ed

MURPHITOJONES69 · Post by **MURPHITOJONES69** » Mon Jul 24, 2023 5:50 pm

I will check when I get home buy I barely put a new one in. Will the code stay on until I clear it? I'm new to hondata 🤣

CalibratEd · Post by **CalibratEd** » Mon Jul 24, 2023 8:00 pm

You should be able to clear the DTC with Kpro.

-Ed

MURPHITOJONES69 · Post by **MURPHITOJONES69** » Mon Jul 24, 2023 10:20 pm

I cleared the codes. Is 12.6% too much for tps minimum reading?

CalibratEd · Post by **CalibratEd** » Tue Jul 25, 2023 4:47 pm

The TPS should read 0%. Did you calibrate the TPS?

-Ed

MURPHITOJONES69 · Post by **MURPHITOJONES69** » Tue Jul 25, 2023 5:43 pm

Yes. Mine reads 12.6 percent on the throttle calibration section after the reading

CalibratEd · Post by **CalibratEd** » Tue Jul 25, 2023 5:50 pm

That’s fine as long as the throttle body is fully opening.

-Ed

MURPHITOJONES69 · Post by **MURPHITOJONES69** » Tue Jul 25, 2023 6:05 pm

Do you think a tune will fix it?

CalibratEd · Post by **CalibratEd** » Tue Jul 25, 2023 6:32 pm

A tune will fix what?

-Ed

Hondata

K24a2 with k20z4 head

K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head

Re: K24a2 with k20z4 head