+++ Help+++ brake line on ecu??

you know i got sol! · Mon Feb 13, 2006 11:22 pm

i have hondata s200.. and it seems that i am not able to set up anything.. (with the button)..(it blinks but when i go to set it with the brake it doesnt detect it)..so rev limiter, launch control, shift light.. etc..are not working.. i read up and have searched.. and i have concluded that the brake line on the ecu might be disconnected or faulty.. the question is which/where is the connector on the ecu has the brake line, so i can replace it.. please if someone can provide a pic.. it would be awesome.. oh yeah i have a 98 obd 2 gsr.. running on obd 1 p28..

Post by **Hondata** » Tue Feb 14, 2006 9:58 am

On the OBDI connector the brake switch is D2. You can check that this pin goes to 12V when the brake pedal is pressed.

you know i got sol! · Post by **you know i got sol!** » Tue Feb 14, 2006 9:25 pm

thanks for your help hondata.. i was curious has anyone installed a swtich (for the brake line) to work it manually? is this a bad idea? has it been done before? sorry for all the noob questions..

Post by **Hondata** » Wed Feb 15, 2006 9:51 am

Are you using an adapter harness or an OBDI ECU with built in OBDII connectors?

you know i got sol! · Wed Feb 15, 2006 12:33 pm

i am using an obd 1 integra ls harness (all neccessary vtec items wired)..on a obd 1 p28 on a obd 2 gsr motor..

Post by **Spunkster** » Wed Feb 15, 2006 1:31 pm

check continuity form the switch to the ecu

you know i got sol! · Thu Mar 23, 2006 10:48 pm

how do i go about doing that?