Kpro malfunction

Kenokpro · Post by **Kenokpro** » Wed Apr 12, 2023 6:33 am

Howzzit. I have a 98 civic couple with a kswap. K20a3 to be exact, my car was running great until all of a sudden the red and green led on my kpro turned on. Anyone know what's happening. Any advise would be appreciated. Thanks guys

Kenokpro · Post by **Kenokpro** » Wed Apr 12, 2023 6:35 am

Howzzit. I have a 98 civic couple with a kswap. K20a3 to be exact, running a old version of k pro. Think it's a kpro v2. . Has the green circuit board my car was running great until all of a sudden the red and green led on my kpro turned on. Check. Engine on dash turned
too. Car can't Rev past 3000 rpm. And fuel economy is super bad.. eating gas like crazy Anyone know what's happening. Any advise would be appreciated. Thanks guys

Post by **Spunkster** » Wed Apr 12, 2023 9:09 am

What is the serial number that is on the K-Pro board inside the ECU?

From Help, About, what is the version of software you are using?

When you datalog, are there any errors?

Kenokpro · Post by **Kenokpro** » Mon Apr 17, 2023 12:37 am

Serial number is 05005698

Kenokpro · Post by **Kenokpro** » Mon Apr 17, 2023 12:39 am

I haven't tried datalonging any runs yet. Just bought the car actually. Was running fine then all of a sudden did this

Post by **Spunkster** » Mon Apr 17, 2023 9:25 am

From Help, About, what is the version of software you are using?

When you datalog, are there any errors?

Kenokpro · Post by **Kenokpro** » Wed Apr 19, 2023 2:13 pm

Well I couldn't datalog because the labtop is unable to read the hondata. It's says unrecognizable when I plug it in. I have the latest version. Of kmanager downloaded on my labtop

Post by **Spunkster** » Wed Apr 19, 2023 3:49 pm

What is the actual version of software?

Hondata