Flashing red light

[Shneaky]

So I recently had someone install my Hondata, and when I go to connect my ecu to the laptop d2 flashes red while d4 stays green.
I tried data logging and it reads nothing. I’m guessing connection isn’t right because I can’t even upload anything.

[Spunkster]

What is the serial number that is on the s300 board inside the ECU?

From Help, About, what is the version of software you are using?

Is J12 cut on the ECU?

[Shneaky]

Serial: 62553
I’m running version 2.8.1.0

[Shneaky]

And no j12 is not cut

[Spunkster]

Is J12 cut on the ECU?

[Shneaky]

No

[Spunkster]

It must be cut.

[Shneaky]

So there shouldn’t be a j12?

[Spunkster]

removed or one leg cut and lifted away from the board

[Shneaky]

Still flashes red

[Shneaky]

And nothing reads for datalogging

[Spunkster]

Are you able to upload?

Did the person that install it test the ECU after socketing it?

[Shneaky]

Would it light red for a second and then start flashing again if it uploads??

[Spunkster]

What happens when you try to upload a calibration?

[Shneaky]

The red light would stay on for about a second or 2 and then start flashing