K24a Basemap
K24a Basemap
I have a K24A swapped 07 Civic Si. I have swapped over all of the necessary OEM parts from the old engine and installed the RBC Intake Manifold as well as the 50° VTC. I have the 8th gen Racing Hondata and want to get it tuned for daily driving
- CalibratEd
- Posts: 1674
- Joined: Fri Feb 07, 2020 3:20 pm
- Contact:
Re: K24a Basemap
Graham,
Per our pm. You are unable to load the Tsx calibration as it is not allowed by Hondata. You are going to have to get a custom tune for your setup utilizing the 8th civic calibration file as a base.
-Ed
Per our pm. You are unable to load the Tsx calibration as it is not allowed by Hondata. You are going to have to get a custom tune for your setup utilizing the 8th civic calibration file as a base.
-Ed
Instagram: calibrated.tuning
Re: K24a Basemap
I found one off another thread and have been using it. Here is a datalog from my last drive.
You do not have the required permissions to view the files attached to this post.
- CalibratEd
- Posts: 1674
- Joined: Fri Feb 07, 2020 3:20 pm
- Contact:
Re: K24a Basemap
Graham,grahamb16 wrote: Sat Dec 17, 2022 11:51 am I found one off another thread and have been using it. Here is a datalog from my last drive.
You need to post the calibration file you are running.
-Ed
Instagram: calibrated.tuning
Re: K24a Basemap
Here ya go
You do not have the required permissions to view the files attached to this post.
Re: K24a Basemap
Graham, I was wondering if you are running an aftermarket I/H/E on your engine? Also, does the car run ok for daily driving on the file you posted?
CalibratEd, I was trying to PM you to pick your brain on something, if you had the time.
CalibratEd, I was trying to PM you to pick your brain on something, if you had the time.
- CalibratEd
- Posts: 1674
- Joined: Fri Feb 07, 2020 3:20 pm
- Contact:
Re: K24a Basemap
Pacalocks,Pacalocks wrote: Wed Dec 28, 2022 5:58 pm Graham, I was wondering if you are running an aftermarket I/H/E on your engine? Also, does the car run ok for daily driving on the file you posted?
CalibratEd, I was trying to PM you to pick your brain on something, if you had the time.
Sure send me a PM
-Ed
Instagram: calibrated.tuning
- CalibratEd
- Posts: 1674
- Joined: Fri Feb 07, 2020 3:20 pm
- Contact:
Re: K24a Basemap
Graham,
I will take a look at the file when I can.
-Ed
Instagram: calibrated.tuning
Re: K24a Basemap
Pacalocks,Pacalocks wrote: Wed Dec 28, 2022 5:58 pm Graham, I was wondering if you are running an aftermarket I/H/E on your engine? Also, does the car run ok for daily driving on the file you posted?
CalibratEd, I was trying to PM you to pick your brain on something, if you had the time.
I swapped the stock intake with the RBC Intake from the k20. Headers and exhaust are still the same, also the 50° VTC from the k20 was installed as well. As far as daily driving, it's been doing well. I haven't had any issues so far
Last edited by grahamb16 on Thu Dec 29, 2022 5:06 pm, edited 1 time in total.
Re: K24a Basemap
No worries mane
- CalibratEd
- Posts: 1674
- Joined: Fri Feb 07, 2020 3:20 pm
- Contact:
Re: K24a Basemap
Graham,grahamb16 wrote: Thu Dec 29, 2022 5:04 pm
No worries mane
I need a longer datalog. I can not do much with 3 seconds lol
-Ed
Instagram: calibrated.tuning
Re: K24a Basemap
Sorry about that, this one should be long enough
You do not have the required permissions to view the files attached to this post.
Re: K24a Basemap
Have you had a chance to look at this yet?CalibratEd wrote: Thu Dec 29, 2022 8:36 pmGraham,
I need a longer datalog. I can not do much with 3 seconds lol
-Ed
- CalibratEd
- Posts: 1674
- Joined: Fri Feb 07, 2020 3:20 pm
- Contact:
Re: K24a Basemap
I would be careful. The car is running very lean. I increased the fuel.
-Ed
-Ed
You do not have the required permissions to view the files attached to this post.
Instagram: calibrated.tuning