2015 FB6 Basemap

[azndeap]

i got a question would i be able to do a burble tune by the end of the revisions? i tried doing with with the 30 cam angle map and it didn't work.

[EFICU]

It looks really good. We will now do one on the 30* cam with vtec at 4000. Take this one for a spin when you can. Same datalog and driving style.

azndeap.SD.Rev04 (30Cam)(Vtec4000).fpcal

[azndeap]

here's the datalogging

[EFICU]

That one looked good too, we will now do one on the 40* cam with vtec at 4300. For this one, you can make a quick ten minute drive if you'd like, the only thing we really need is the clean third gear WOT pull. After this, we blend it out to how it feels with all the tables set.

azndeap.SD.Rev05 (40Cam)(Vtec4300).fpcal

[azndeap]

here's the quick wot 3rd gear

[EFICU]

That one looked good too. So I've gone in blended all the tables including the cam angle map. Take this one for a spin and see what you think. Vtec looks happiest at 4500, but we can try moving it up or down a little if you want. Go back to the twenty minute datalogs with at least one third gear WOT pull, but feel free to have some fun with it and drive it however you want.

azndeap.SD.Rev06 (Blended)(Vtec4500).fpcal

[azndeap]

I had a little too much fun. Here it is.

[EFICU]

Looks like just the right amount of fun, haha. It all looks really good, I made a couple of fuel adjustments and some ignition for knock. Take this one for a spin when you can. On the third gear pull, try to get it down to 2500 and then go WOT all the way to 7500 just so I can finalize that fuel and ignition stuff. But feel free to have some fun with it again if you want, it all looks plenty safe and looks like it runs pretty strong, just be safe out there.

If you add a DP in the future, or any other performance mod actually, you will need some injectors. Right now you're around 90% at redline, so you're right on the edge there for recommending them, but not actually "needing" them. So if you add something in the future, I would throw in some genuine RDX injectors which would give you plenty of room. You could add them now if you want, but I wouldn't say it's a requirement at this point.

azndeap.SD.Rev07 (Blended)(Vtec4500).fpcal

[azndeap]

i have the DP installed already ... full race 3 inch. I'll have the RDX injectors soon When i put in my RBC IM. currently gathering parts right now for the swap. i'll datalog that map tomorrow when i have the chance.

[EFICU]

That's right, sorry I forgot about you installing the DP. That makes more sense about the duty cycle being so high then. Sounds good on the intake and RDXs, just be sure to get OEM RDX and not Amazon or eBay ones.

We'll see how it looks tomorrow.

[azndeap]

It feels very strong. I appreciate every thing. Here's 20 mins of datalogging

[EFICU]

Yeah it looks good, you're welcome. No knock in this one, so that's good. I made a couple small fuel adjustments, so take this one for a spin when you cam. No rush, it's 99% there, I'm just nitpicking at this point.

azndeap.SD.Rev08 (Blended)(Vtec4500).fpcal