need help with tune

[reyez_fa5]

the vtec feels about right

[EFICU]

Unfortunately this datalog is only a minute and a half long. You might have hit the button the FlashPro twice or something. You'll have to make a new datalog unfortunately, sorry.

[reyez_fa5]

did it on both just incase

[EFICU]

Yeah it looks really good. We will now do one on the 30* cam with vtec at 4000. Take this one for a drive when you can, for this one, you can do a ten minute drive. The main thing we need is that clean third gear WOT pull basically.

Reyez_fa5.SD.Rev06 (30Cam)(Vtec4000).fpcal

[reyez_fa5]

heres the next drive

[EFICU]

Looks good again, we will do one on the 40* cam angle now just to see how much of this angle it likes for WOT. This is another one you can do a ten minute datalog, just be sure to get a clean third gear pull. This will be the last one locked on one cam angle, after this we blend it out and see how it runs.

Reyez_fa5.SD.Rev07 (40Cam)(Vtec4500).fpcal

[reyez_fa5]

its getting better and better

[EFICU]

It looks really good. It's run out of breath now on the 40* cam angle, so I've gone in and blended everything out now. This is the first one with the cam angle map set, so take it for a drive and see what you think. Vtec looks happiest at 4800, but we can move it up or down a little to test if you want. Feel free to have some fun with it, just be sure to get around twenty minutes of datalog time and at least one third gear WOT pull. Other than, feel free to have some fun with it, just be safe out there.

Reyez_fa5.SD.Rev08 (Blended)(Vtec4800).fpcal

[reyez_fa5]

thanks brother

[reyez_fa5]

thanks brother

[EFICU]

Yeah it looks great man. I made a couple small fuel adjustments, but it's pretty much there. Go ahead and make another datalog when you can, no rush at all. It's 99% there so feel free to make a datalog when you drive somewhere of whatever, no need to go out and make an aimless datalog unless you want to.

Reyez_fa5.SD.Rev09 (Blended)(Vtec4800).fpcal