erase ecu

[iamwormy]

for some reason after registering my vin and stuff with hondata, its still not letting me erase the ecu so i can upload a different stock tune. if anyone knows the answer to this please, its an ecu from a b18 integra and im running it in h22 swapped prelude so it cant even run well right now

[Hondata]

You don't need to erase the ECU. Just open a calibration and upload it.

[iamwormy]

And if it doesn't allow me to open a new calibration?

[Spunkster]

From Help, About, what is the version of software you are using?

What is the serial number on the s300 inside the ECU?

[iamwormy]

Im using version 2.7.8 and the serial is 54374 (i think its the serial)

[Spunkster]

Is J12 cut on the ECU?

[iamwormy]

I completely removed j12 from the board

[iamwormy]

Is J12 cut on the ECU?

Ecu uploads fail almost immediately. Is it my socketing? Could it be from not installing the resistor in r54? I have a p72 ecu and i wasnt sure it the r54 needed to be soldered in or not. I also completely removed j12 from the board instead of cutting it. Does that make a difference?

[Spunkster]

Post a picture of the soldering on the bottom of the ECU.

[iamwormy]

Thank you all for your effort in troubleshooting this guys, it was just my bad soldering (first timer) i went back and redid some the suspect ones and now it works perfectly