Serious Problems

jsimon9633 · Post by **jsimon9633** » Thu Jan 05, 2006 4:57 pm

I am having a serious idle issue, it wont stay at what i set it and surges from 1-2k

what kind of mechanical things can cause this?

i have a boosted rsx with kpro

i have already changed my 3 bar map sensor and tried everything software wise to fix it and cant

Post by **Spunkster** » Thu Jan 05, 2006 5:53 pm

clean out your idle control valve

jsimon9633 · Post by **jsimon9633** » Thu Jan 05, 2006 7:51 pm

Spunkster wrote:clean out your idle control valve

already did it

Razathorn · Post by **Razathorn** » Thu Jan 05, 2006 8:02 pm

Datalog and calibration? What about manifold pressure when this is happening. A datalog would get that too.

Wayne

jsimon9633 · Post by **jsimon9633** » Thu Jan 05, 2006 8:26 pm

Razathorn wrote:Datalog and calibration? What about manifold pressure when this is happening. A datalog would get that too.

Wayne

I will do this thanks

jsimon9633 · Post by **jsimon9633** » Fri Jan 06, 2006 11:47 am

ok heres the problem im encountering

with a map sensor that works a 3 bar, that ive tested using the voltage test the car wont start

the car starts with a bad 3 bar map BUT the kpro is in the wrong columns , it thinks it sees boost

menfou · Post by **menfou** » Sat Jan 07, 2006 4:39 am

Where do you plug your 3bar map sensor ?
Do you try with the stock map sensor ?

Don't plug the 3bar map sensor anywhere

jsimon9633 · Post by **jsimon9633** » Sat Jan 07, 2006 7:26 am

menfou wrote:Where do you plug your 3bar map sensor ?
Do you try with the stock map sensor ?

Don't plug the 3bar map sensor anywhere

i guess i will try that next unfortunately i lost the stupid plug fo rthe stock one

menfou · Post by **menfou** » Sat Jan 07, 2006 10:21 am

Where do you put the map sensor ?
Do you have a datalog ?

jsimon9633 · Post by **jsimon9633** » Sat Jan 07, 2006 2:56 pm

menfou wrote:Where do you put the map sensor ?
Do you have a datalog ?

no datalog cause car wont even start

on the bad 3 bar it just starts and sounds fucked up cause its in boost column

the 3 bar is located near the battery

i tapped vacuum off the fpr

menfou · Post by **menfou** » Sun Jan 08, 2006 2:08 am

you don't have picture ?
Why do you remove your stock map sensor ?

jsimon9633 · Post by **jsimon9633** » Sun Jan 08, 2006 10:11 am

here is a datalog of the car

menfou · Post by **menfou** » Sun Jan 08, 2006 3:28 pm

Your MAP values are corrects no ?
I don't understand your problem :?:

jsimon9633 · Post by **jsimon9633** » Sun Jan 08, 2006 3:36 pm

menfou wrote:Your MAP values are corrects no ?
I don't understand your problem :?:

the problem is that the only way the car ran ok was using the alpha-n feature which is not suppose to be used for forced induction which i have lol

cant seem to get it right with normal 3 bar MAP settings