S300 v3 CAN output

[aklackner]

In CAN output documentation there are values for knock/detonation in the Hondata CAN protocol, though it’s noted this is only available on kpro.

I’m using an s300 v3 in a p72-a01 with knock board so in this case values should be in the ecu. Will the s300 send these in this case or does the s300 simply not output?

[Spunkster]

This is not used on the s300.

http://www.hondata.com/help/smanager/ca ... tsub=motec

[aklackner]

Thanks for confirming