S2000 Kpro Low/High Boost

AngryScottish · Post by **AngryScottish** » Sun Oct 31, 2021 8:28 pm

Spunkster wrote: Mon Oct 25, 2021 9:48 am What is the serial umber on the K-Pro board inside the ECU?

Not sure which one you needed, so took a photo and attached.
But, it's a PPA ECU:
37820-PPA-A07

Post by **Spunkster** » Mon Nov 01, 2021 10:50 am

That is not the serial number on the K-Pro board.

AngryScottish · Post by **AngryScottish** » Mon Nov 01, 2021 8:55 pm

Spunkster wrote: Mon Nov 01, 2021 10:50 am That is not the serial number on the K-Pro board.

My bad, you did say kpro board.

47206.

Post by **Spunkster** » Tue Nov 02, 2021 9:24 am

This ECU has not been prepared for use in an S2000, and a PPA ECU is not supported for use with the S2000.

AngryScottish · Post by **AngryScottish** » Tue Nov 02, 2021 3:29 pm

Spunkster wrote: Tue Nov 02, 2021 9:24 am This ECU has not been prepared for use in an S2000, and a PPA ECU is not supported for use with the S2000.

This is unrelated to a S2000. I am just posting in the thread because of the low/high boost issue that the OP was discussing.

Post by **Spunkster** » Tue Nov 02, 2021 3:59 pm

I recommend you start your own thread so there is no confusion then.

Hondata