Requesting a B20V basemap

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
anonymous408
Posts: 14
Joined: Tue Nov 17, 2020 7:04 pm

Re: Requesting a B20V basemap

Post by anonymous408 »

CalibratEd wrote: Wed Jun 30, 2021 7:43 pm Load the tune and datalog the car normal driving. I smoothed out the map to have a base to work with.

-Ed
Cool thanks! Alright let me try it out. Should I stop-n-go traffic? WOT perhaps?
User avatar
CalibratEd
Posts: 1674
Joined: Fri Feb 07, 2020 3:20 pm
Contact:

Re: Requesting a B20V basemap

Post by CalibratEd »

anonymous408 wrote: Thu Jul 01, 2021 11:13 am
CalibratEd wrote: Wed Jun 30, 2021 7:43 pm Load the tune and datalog the car normal driving. I smoothed out the map to have a base to work with.

-Ed
Cool thanks! Alright let me try it out. Should I stop-n-go traffic? WOT perhaps?
Stop and go driving for now. I want to asses how the fueling is doing.

-Ed
Instagram: calibrated.tuning
anonymous408
Posts: 14
Joined: Tue Nov 17, 2020 7:04 pm

Re: Requesting a B20V basemap

Post by anonymous408 »

I tried it out just now. I had to adjust the IAC to get it up for the first time. Initially it wouldnt continue to run once I started it. Then I removed the FPR vacuum line then started again and it idled fine. After idle is fine I plugged the vacuum hose back in and went for a drive.

After shifting gears and about to come to a stop I press in the clutch then it died out. Only way to start it up is to press on the gas a little to give it more air and off I go.

You can check out the datalog file here. Thanks for looking into it!
You do not have the required permissions to view the files attached to this post.
anonymous408
Posts: 14
Joined: Tue Nov 17, 2020 7:04 pm

Re: Requesting a B20V basemap

Post by anonymous408 »

anonymous408 wrote: Thu Jul 01, 2021 12:57 pm I tried it out just now. I had to adjust the IAC to get it up for the first time. Initially it wouldnt continue to run once I started it. Then I removed the FPR vacuum line then started again and it idled fine. After idle is fine I plugged the vacuum hose back in and went for a drive.

After shifting gears and about to come to a stop I press in the clutch then it died out. Only way to start it up is to press on the gas a little to give it more air and off I go.

You can check out the datalog file here. Thanks for looking into it!
Oh and AFR does go from 15ish to around 14.7, hiccup here and there but it managed to come down between those two numbers.
User avatar
CalibratEd
Posts: 1674
Joined: Fri Feb 07, 2020 3:20 pm
Contact:

Re: Requesting a B20V basemap

Post by CalibratEd »

I am cleaning up the fuel so it might run a little sluggish for now. Load the new tune and create another normal driving log. Try to get higher in the RPM with out going WOT.

-Ed
You do not have the required permissions to view the files attached to this post.
Instagram: calibrated.tuning
anonymous408
Posts: 14
Joined: Tue Nov 17, 2020 7:04 pm

Re: Requesting a B20V basemap

Post by anonymous408 »

CalibratEd wrote: Thu Jul 01, 2021 7:24 pm I am cleaning up the fuel so it might run a little sluggish for now. Load the new tune and create another normal driving log. Try to get higher in the RPM with out going WOT.

-Ed
It feels more sluggish. Died on the road couple of times when clutch was pressed in. Runs 17sh AFR. Heres what I have for the datalog.
You do not have the required permissions to view the files attached to this post.
anonymous408
Posts: 14
Joined: Tue Nov 17, 2020 7:04 pm

Re: Requesting a B20V basemap

Post by anonymous408 »

anonymous408 wrote: Thu Jul 01, 2021 9:18 pm
CalibratEd wrote: Thu Jul 01, 2021 7:24 pm I am cleaning up the fuel so it might run a little sluggish for now. Load the new tune and create another normal driving log. Try to get higher in the RPM with out going WOT.

-Ed
It feels more sluggish. Died on the road couple of times when clutch was pressed in. Runs 17sh AFR. Heres what I have for the datalog.
Okay I tried to fix the idle stop screw and now its idling at around 14ish, not the previous 17sh I mentioned. Too late to test drive it now but I will tomorrow. I just hope I dont die again lol.
User avatar
CalibratEd
Posts: 1674
Joined: Fri Feb 07, 2020 3:20 pm
Contact:

Re: Requesting a B20V basemap

Post by CalibratEd »

I added a lot more fuel to this revision. I will trim the fuel out once we make sure the car is not leaning out on you.

-Ed
You do not have the required permissions to view the files attached to this post.
Instagram: calibrated.tuning
Post Reply