S300v3 to Aem cd7 dash

[mboettigheimer]

Hey what’s up guys. I’m trying to troubleshoot why my dash isnt reading any can data. Iv troubleshot with Aem for their dash,checked wiring, and checked I was getting 60 ohms between high and low. How do I check if the s300 itself is sending can data at all?

[Spunkster]

From Help, About, what is the version of software you are using?

[mboettigheimer]

It should be the latest. I installed the software not too long ago. I’ll have to check

[mboettigheimer]

It is 2.7.6.0

[Spunkster]

Try using the most recent beta version : http://www.hondata.com/forum/viewtopic.php?f=19&t=24495

[mboettigheimer]

Awesome! I’ll try that out when I get home from work!

[mboettigheimer]

That definitely worked. Thanks Spunkster!

[mboettigheimer]

Back again lol. Updated some of the analog inputs and now my aem cd7 is not receiving any info from s300. Dash was working right before I uploaded to ecu. My baud rates match up, I have the 120 ohm resistor in. I even updated to 7.8. Sometimes the dash says can2 disconnected, sometimes it says can2 recieve timeout.

[mboettigheimer]

I figured it out. Was a configuration problem on the aem side.