Motec 3 Bar Settings in Kpro

jsimon9633 · Post by **jsimon9633** » Tue Nov 15, 2005 11:13 pm

Ok I am having an issue with this

it seems that at idle it reads 2lbs of boost and hence its screwing up my whole thing

I am using the kpro default settings of 609 scalar and 2 offset for the motec 3 bar map

I have a vacuum manifold source im getting directly from the intake manifold

I have a vacuum connected to the botom port of wastegate and my type r greddy bov

i do not have the vacuum line connected to the port on the turbo yet, would this affect anything?

what settings have you guys used on the motec 3 bar to get it to work right on kpro? thanks!!
__________________

Post by **Hondata** » Wed Nov 16, 2005 9:46 am

It seems like the MAP sensor is damaged - try another sensor. The MAP sensors are delicate - incorrect wiring or a short for even the briefest moment will damage the sensor.

Post by **Spunkster** » Wed Nov 16, 2005 10:37 am

Also make sure that the stock map sensor is no longer wired in.

jsimon9633 · Post by **jsimon9633** » Wed Nov 16, 2005 2:12 pm

anyone have the wiring diagram that comes with motec?

I tried to search for it but no luck

I have 3 wires

green/black, red/black, and yellow/black

which wire goes to which letter on the 3 bar? A. B and C?

Post by **Spunkster** » Wed Nov 16, 2005 3:12 pm

http://www.hondata.com/tech3barmap.html