E85 cold start in new york

FlashPro questions & answers specific to the 2006-2011 Americas Civic Si
Post Reply
k24_chris
Posts: 11
Joined: Tue Dec 13, 2016 10:58 am

E85 cold start in new york

Post by k24_chris »

Hi just wondering how can I adjust my map to turn the car on cold start. It’s 30 degrees here in New York and my si is a built motor. K24a2 block 12.5 bc rods supertech springs and retainers and valves skunk2 ultra 4 cams. Full ported Xsseive side feed ktuned 72mm 4” cai id 1000cc injectors. Walbro 255 on e85.
You do not have the required permissions to view the files attached to this post.
User avatar
Spunkster
Site Admin
Posts: 23878
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: E85 cold start in new york

Post by Spunkster »

Have you discussed this with your tuner?

You may have to reduce the amount of ethanol in cold weather.
k24_chris
Posts: 11
Joined: Tue Dec 13, 2016 10:58 am

Re: E85 cold start in new york

Post by k24_chris »

I tried calling my tuner but no answer. How can I reduce the amount of ethanol?
User avatar
Spunkster
Site Admin
Posts: 23878
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: E85 cold start in new york

Post by Spunkster »

put less ethanol in the tank
User avatar
Hondata
Site Admin
Posts: 10615
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: E85 cold start in new york

Post by Hondata »

Look at the Calibration -> Ethanol -> Ethanol ECT cranking table and either post the calibration or tell us what is in it.
Hondata
k24_chris
Posts: 11
Joined: Tue Dec 13, 2016 10:58 am

Re: E85 cold start in new york

Post by k24_chris »

i think i figured it out. in the cranking fuel trim table, the 1st column from 0 rpm - 2000 rpm i raised it by 15% and the car started.
You do not have the required permissions to view the files attached to this post.
Post Reply