p2185

[ckj134]

Hello, I got my ECU replaced and programmed to my immobilizer, I think I got the vehicle tune not sure it does the tune under 15 seconds, the online videos I am seeing all say it should take 5 mins but those are for civics, anyway after I got the tune done I keep getting this code P2185 ECT SENSOR CIRCUIT HIGH VOLTAGE.

[Spunkster]

If it only takes 15 seconds to upload, then it is not uploading to the ECU. What does it show in the lower left corner of the software when you are trying to upload?

[ckj134]

in the bottom everything is green expect the the logo that says that the ecu is locked or that the flash pro is locked.

[Spunkster]

With everything plugged in and the ignition in the on position, go to the Help menu and click on “send feedback”. Include a detailed description of the issue.

[ckj134]

right now the code im getting is p2185 thats my only issue for now, but I will try that.

[ckj134]

So for whatever reason the flash pro was putting the tune into the obd2 dongle not my vehicle, I hooked up the flash pro held down the program button the dongle started flashing different ways saw some action on my dash check engine came off.

I adjusted these settings not sure if I did thus correctly

[Spunkster]

Was the FlashPro plugged into the vehicle with the ignition on when you were uploading to it?

[ckj134]

Yes I had the vehicle in the on position, held the program button it was solid then it started to flash a few mins and some lights in the dash came on and off, last thing it did was the check engine when on and off, it never did this while I had the computer plugged in.