2016 International Civic 1.5T Knock Sensitivity Table

[arnoldod]

I updated Flashpro from 3.6.2.0 to 3.6.3.0 and updated to 3.6.4.0 a day after 3.6.3.0.

I found out in the 3.6.4.0 Flashpro 2 new tables under Knock Control: Knock sensitivity low cylinder 1-4 and Knock sensitivity low cylinder 2-3.

I know these tables were available in SI calibration but they weren't available in the 1.5T calibrations.

I didn't find this update in 3.6.4.0 update log. Can I check with you if these tables were newly added for 1.5T?

[gcapraz]

dear arnold,
some ecu has that table and some ecu doesnt have. i guess it depends on the ecu capability.

by the way you should be carefull with knock sensitivity tables. if you make very much desensitive, you can run with lots of knock without knowing it.

[arnoldod]

dear arnold,
some ecu has that table and some ecu doesnt have. i guess it depends on the ecu capability.

by the way you should be carefull with knock sensitivity tables. if you make very much desensitive, you can run with lots of knock without knowing it.

I asked this question because these tables weren't available in the past.

I'm fully aware of the risk from altering knock sensitivity tables & I have no intention to make any changes to these tables.

Hondata & Sprunkster could you please validate & confirm?