Kpro - Analogue input Pins

[Lyle_57IAL]

Good Morning Hondata,

Was wondering if there were any pins available on the factory loomb / plugs to use for a analogue input.

Like the S300 / Smanager, OEM pins can be reused to take an analogue signal. ie - D10, D12, D14, B6 .

Are there Original pins that can be used in the Kpro in the same way ? or is the only way to get an external analogue signal into the Kpro via the secondary pigtail on the circuit board (analogue inputs 0 - 7)

TIA

[Hondata]

The only option is to use the analog input pins on the KPro3/KPro4