Good Evening Hondata,
Currently i have a OEM standard K24a3 utilising a Kpro, with bosch 750cc injectors (deadtimes set), 50psi base fuel pressure, walboro 450 fuel pump. Have a strange issue at idle where the ignition tables are specifying 20 degrees... however the ignition timing delivered (through watching the Ignition timing data on the display) is around 1 degree.
Please see attached datalog and map. Multiplexer disabled, VTC table is Zeroed out, Set in open loop, knock sensor disable etc.
Any insight to this behavior would be much appreciated.
Lyle
K24a3 - offset ignition timing offset at idle
-
Lyle_57IAL
- Posts: 146
- Joined: Wed Jul 25, 2012 5:42 pm
K24a3 - offset ignition timing offset at idle
You do not have the required permissions to view the files attached to this post.
-
Lyle_57IAL
- Posts: 146
- Joined: Wed Jul 25, 2012 5:42 pm
Re: K24a3 - offset ignition timing offset at idle
Apologies guys here is the datalog
You do not have the required permissions to view the files attached to this post.
Re: K24a3 - offset ignition timing offset at idle
This ECU uses ignition to control idle so it will fluctuate a lot when it is idling.
-
Lyle_57IAL
- Posts: 146
- Joined: Wed Jul 25, 2012 5:42 pm
Re: K24a3 - offset ignition timing offset at idle
Yes but whats in the ignition table... does not match what ignition timing is being delivered.
Re: K24a3 - offset ignition timing offset at idle
that is normal at idle.
-
Lyle_57IAL
- Posts: 146
- Joined: Wed Jul 25, 2012 5:42 pm
Re: K24a3 - offset ignition timing offset at idle
Really ? Specifying 20 degrees and having -1 delivered ?
Re: K24a3 - offset ignition timing offset at idle
Yes, it is normal. The ECU uses ignition to control the idle rpm.
Hondata