VSS Issue - CRV/Element AWD Trans - Speedo working - Kpro not

[Jensenka]

I am having issues with my vss signal to the kpro. It is not reading and is throwing a CEL. Speedo in the cluster is working properly (though a little off of speed). I have tried both Normal and Countershaft speed sensor options in Kmanager. I believe it should be the normal speed sensor setting, but am having trouble finding the right information. Here is the setup:
96 Civic DX
K24a2 motor
RSX base 5 speed harness
PND 5 speed Kpro V4 using 4.4.3 Kmanager
Element trans (I believe from 03-10 range) for AWD setup - should be same as CRV

I have also updated the gear ratio's as there is not a setting for the CRV/Element Trans.

So does anyone know what is needed here? Do I need a frequency conversion for the sensor? Since it seems to be off of the final drive, this didn't seem likely, but maybe it is a different frequency than the standard RSX trans. Not sure what is going on since the speedo is working but Kpro is not.

Thanks for any help that can be provided.

[Spunkster]

What is the serial number that is on the K-Pro board inside the ECU?

What is the ECU part number on the white plug inside the ECU?

[Jensenka]

Kpro serial number 51844
ECU number 37820-PND-A51

[Spunkster]

You do not have a manual ECU. It is an automatic and does not have a VSS input. More details can be found at: https://www.hondata.com/tech-alternativ ... ngine-swap

[Jensenka]

Guess that is what happens when you buy one “on sale” and am not able to specify the ECU used. However this procedure looks pretty straight forward. I will get on this soon.

Thanks