Kpro settings help with quaife sequential

[dc5itr01]

Can anyone please help with the settings in kpro when using quaife sequential tranny.
Many people I spoke with says that kpro is not good for sequential boxes.
I dont believe this. I think people give up to quickly.
Surely there is someone out there who has had success and is willing to share 3 settings please?

Also,
Is there an easier way of sending the signal from the tranny?
Strain Gauge Input

The KPro does not support a strain gauge input directly.  However, you can implement a shift cut using a strain gauge by converting the stain gauge voltage to a signal for the shift input.

To do this you can either use a purpose designed converter (eg the K-Tuned programmable interface) or by using a  'voltage comparator module'.

The voltage comparator module compares the strain gauge voltage with an adjustable threshold, and activates an output (often a relay) when the voltage reaches that threshold.  That output can be used as the shift input.