Problems right before VTEC kickes in

K-Series Programmable ECU installation questions / support issues
Locked
Travisk0024
Posts: 2
Joined: Fri Sep 23, 2005 2:37 pm
Location: Key West

Problems right before VTEC kickes in

Post by Travisk0024 »

I have been having a problem when I get my car to about 5500 rpm it starts making a odd noise and I lose a lot of power and once the VTEC kickes in it is not much better. I have noticed that the longer I make it go in to the higer rpm's my mil light will flash. It flashes about once a sec and on the data log I have here it was flashed 14 times. It does not happen in 1st gear and I do not thing that it does in 2nd the main problem in when I am in 3-5 and I am goign to pass a car. I can not figure ont what is making this happen please help!!
You do not have the required permissions to view the files attached to this post.
User avatar
Hondata
Site Admin
Posts: 10616
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Post by Hondata »

The A/F shows lean from 5700 rpm upwards. There is some knock sensor activity as well, but not much. The short term fuel trim is high (-15%) at idle. First check that there is no mechanical cause of the 6000 rpm problem (only likely if you have swapped cams) otherwise you need tuning.
Hondata
Locked