I have just purchased a hondata v3 and had Eric Jarvis install it at madscientist auto in Kentucky. I plugged it in and uploaded my tune and nothing is happening. Car won’t start and none of the sensors are ready on the data logging.
Also j12 is cut. I checked the soldering on the ecu and they all look good in my opinion
Hondata v3 red light flashing
-
S_congrove09
- Posts: 3
- Joined: Wed May 06, 2020 5:57 pm
Hondata v3 red light flashing
You do not have the required permissions to view the files attached to this post.
-
S_congrove09
- Posts: 3
- Joined: Wed May 06, 2020 5:57 pm
Re: Hondata v3 red light flashing
Better pics of the soldering if needed
You do not have the required permissions to view the files attached to this post.
-
S_congrove09
- Posts: 3
- Joined: Wed May 06, 2020 5:57 pm
Re: Hondata v3 red light flashing
Another thing i noticed is the check engine light doesn’t go off after turning the key on.
Re: Hondata v3 red light flashing
Have the capacitors been replaced on the ECU?