2012 SI Calibration Help

[Rmart980]

I have a Taketa intake full race catted exhaust and full race cat back exhaust. I'm running the MAF base right now. It feels pretty good but got a P0172 the other day. I don't know how to tune any of it.

[EFICU]

Do you have any datalogs we can look at showing the issue?

Which calibration are you running right now?

[Rmart980]

This data log is on the SRI,full exhaust base....I put this base on this morning and drove to get food. the mods are basically what I have but this was the worst the car has ran yet....

[EFICU]

Yeah it's definitely running rich. So the car drove worse with this map in it than it did with the one you were driving on and got the CEL code?

I will attach a file below for you to start on. This is just a 0* cam angle map to see how things look. It may seem a little sluggish at first because there is no cam angle in it. I just want to try and get the fueling close before we make a bunch of changes. Take this one for a drive just like your datalog you posted, same driving style, then post it on here so I can look at it. Also Rmart, please fill out the customer info section under "calibration" for me so I have your information for my records.

This file is for Rmart to start on and is only tuned for the 0* cam angle and will only utilize the 0* cam angle for anyone who downloads it. Don't use this file unless you plan to tune each cam angle individually starting with the 0* cam angle.

Rmart980.SD.Rev01.2 Test(0 cam only).fpcal

[Rmart980]

ok I will give it a try and post back...I was on the MAF tune when the cel came on. I had been running that tune for a week. but thought to try out the other this morning to see what it did.

[Rmart980]

ok here it is, I had 101 knocks on the app when I did that data log

[EFICU]

No problem. We'll get rid of the knocks, they were all clumped in two main areas so I cleaned those up for you. Make sure you fill out the calibration section in this next tune and repost it with a new datalog so I have more information.

Here is the next one for you.

Rmart980.SD.Rev02.fpcal

[Rmart980]

This is what we got..feeling better, it feels like it has a slight bog when vtec hits. I emailed you back the info you requested. Thanks

[EFICU]

Here is the next one. Now you will be on the 15* cam angle for this one. Try to make the datalogs 20 minutes or so from here on out so we can build up quite a bit of data in each datalog. Same driving style though.

Rmart980.SD.Rev03 (15cam).fpcal

[Rmart980]

alright got a good 30mins on this one.

[EFICU]

Here is the next one. Now on the 30* cam, vtec will be at 5500 on this next one. Just moving it around to tune around the vtec engagement.

Rmart980.SD.Rev04 (30cam)(Vtec5500).fpcal

[Rmart980]

ok, that was feeling the best yet!

[Rmart980]

didn't add in the last post

[EFICU]

Here is the next one, vtec is at 3800 now, still on the 30* cam.

Rmart980.SD.Rev05 (30cam)(Vtec3800).fpcal

[Rmart980]

Good morning. This is what we got on that one. Running great so far!!