Nitrous just stoped working

[r@mon]

nitrous was working fine and had gone through about 6 bottles. then i went back in to the kal and adjusted the fuel trim for some new rc 750's i got, after tunnig the 750 i was ready to check the nitrous tune but it wouldnt spray. it would acknowldge the arming input but it wouldnt give me a output.
only thing i noticed wierd is that the tps maximum would keep reseting itself to 0 after a couple uploads. i dont know what is going on. any help?

[Spunkster]

are you usign the romulator or burning a chip?

[r@mon]

its a kpro, no chips to burn

[Spunkster]

Sorry..didn't notice the forum is was in.

Have you recently changed versions of K- Manager?

[r@mon]

well i had made the kal in 1.2.0.7 i downloaded the 1.2.0.9 beta onto the computer but i i only open the kal on it, i never saved it. would that be enough to screw me up? if so, how can i go about fixing it. should i just open a new map alltegether and just copy and paste the figures into a 1.2.0.7 kal?

[Spunkster]

Try saving the calibration in the newer version then reopening it and uplaoding it to the ecu.

[wdsonny]

One thing I have noticed lately, the nitrous control panel will lose the output randomly. You have to go back in and "reset" the output.

[r@mon]

yah i noticed that also, about the saving in the newer version, tried that alos, still no dice. the tps engagement maximum keeps resetting itself to 0. i also tried reinstalling 1.2.0.7 and doing the same and still no dice. i think 1.2.0.9 messed something up in the kal.

[r@mon]

got it to work, i reinstalled 1.2.0.9 and then reopened it and saved it under the beta version and its holding the settings now