Integra Crank no Start - S300 Code 21
-
TurboTeg332
- Posts: 75
- Joined: Thu Jul 25, 2019 1:50 pm
Re: Integra Crank no Start - S300 Code 21
Try this.
You do not have the required permissions to view the files attached to this post.
-
TurboTeg332
- Posts: 75
- Joined: Thu Jul 25, 2019 1:50 pm
Re: Integra Crank no Start - S300 Code 21
Loaded JDM stock B18C 240cc injectors calibration.
Car will not start only cranks. No error codes but was throwing knock sensor code earlier. Car ran fine on stock ECU and with S200 computer J1 cut.
Attached is the datalog recording. Noticed the tach jumps a little when turning key to the ON position and car tries to deisel with key in ON position sometimes when S300 unit plugged up.
Car will not start only cranks. No error codes but was throwing knock sensor code earlier. Car ran fine on stock ECU and with S200 computer J1 cut.
Attached is the datalog recording. Noticed the tach jumps a little when turning key to the ON position and car tries to deisel with key in ON position sometimes when S300 unit plugged up.
You do not have the required permissions to view the files attached to this post.