auto ecu with manual gearbox

assix · Post by **assix** » Sun Sep 25, 2005 8:24 pm

Hi guys...

i've already installed a D15B (vtec sohc) into my car. that engine came with an auto trans but i changed with my old manual trans. so now the status is, ecu - auto but gearbox - manual. its really hard to get the manual D15B vtec sohc here! my question is:
- is it harmfull to my engine/ecu/performance or related if i continued to use this ecu?
- any suggestions on how to mod that ecu to make it compatible with da engine?

thanks a lot...

Post by **Spunkster** » Mon Sep 26, 2005 10:03 am

what ecu are you using?

assix · Post by **assix** » Mon Sep 26, 2005 9:16 pm

Spunkster wrote:what ecu are you using?

PO8 i think... for Civic EG8 (JDM)

Post by **Spunkster** » Tue Sep 27, 2005 9:25 am

You can use the s100, s200 or s300 on that ecu and properly tuned it will run great.

assix · Post by **assix** » Tue Oct 04, 2005 2:07 am

Spunkster wrote:You can use the s100, s200 or s300 on that ecu and properly tuned it will run great.

Thanks a lot, Spunkster.

Post by **Spunkster** » Tue Oct 04, 2005 9:24 am

I must make a correction...the s300 will not fit in that ecu, bu tthe others will. Included in the installation manual are instructions on how to convert the ecu to manual.