Kpro v4 Analog input problem

[Garrett_si]

Hi, I have a K24 engine, I use a AEM 0-150psi pressure sensor on input Analog 0

The display in psi was working a few week ago when I calibrate it, but now I see over 800psi in the display.

I verify the input voltage but changing the Sensor setting from Pressure to Raw voltage, and input voltage still fine.

I attached files and calibration + screen shot

[Garrett_si]

Here is the files and screen shots

[Spunkster]

Post datalogs that show the issue. Screenshots are not enough.

[Garrett_si]

Here is the datalog file

[Spunkster]

That is your calibration and not a datalog.

[Garrett_si]

sorry

here is the log

[Garrett_si]

here is the log

[Garrett_si]

Did you see something wrong?

[Spunkster]

What oil pressure sensor are you using?

Can you post a Datalog that shows the raw voltage?

[Garrett_si]

Sensor is honeywell 0-150psi
Raw voltage could be seen is Hondata software allow it like other standalone I think it's a necessity