Flashpro Manager 3.2.8.0 version box error

[Rush]

hondata 1.JPG

Flashpro seems to have a conflict with the current 3.2.8.0 Manager. Tune seems to have loaded correctly.

[Spunkster]

Are you getting this message after you have uploaded to the ECU using 3.2.8 software?

[Rush]

It happens when I connect the Flashpro to the computer. The Flashpro had the tune loaded on 3.2.8.0. I deleted the tune and reloaded 3 times to the Flashpro and same box appears each time.

[Spunkster]

But did you actually upload the calibration to the ECU?

[Rush]

Yes. It took 2 tries. First had an engine light emission code. Second try all went well, no errors.

[Spunkster]

And it is telling you the calibration is still out of date after uploading to the ECU now?

[Rush]

Correct. Each time I connect the Flashpro to the Manager the box appears.

[nappco]

....2018 Hatch MT

I have the same message. It started for me when I updated a few weeks or so with version 3.2.6. I hadn't touched it or reflashed since last summer. I also had an update error that reported with 3.2.6 when I was flashing the ECU... about 1/4 into the flash it said there was an error, then after a min it started reloading again.I think the upload didn't take. The Hondata Mode seemed to be stock tuning. I have no screen shots.

I updated with 3.2.8.0 last night and haven't had a chance to see if the tune is good.

[nappco]

Well, I think there is a firmware problem. I flashed my original tune and its still not correct. I've attached the tune from July 2018. I think there is a problem with either the traction control or boost by gear. Hope this helps

[Hondata]

The message 'Calibrations stored on the FlashPro are from a previous ...' is normal after an update.

[nappco]

Thanks, any thoughts on the update? There was a major downgrade in performance after this update.

[nappco]

I put the factory tune back in and verified the new version is not working correctly. There is no difference in performance.