3rd gear pull a/f help

[swhangin]

Hello I am looking for any help I can get with this. Its a 3rd gear pull that needs tweaking of A/F. I am curious if anyone can help I am just looking to smooth this out as I have to move in 2 weeks and all the dyno places have lead time of months and cannot help at this time. Im just looking to drive it without any issues to the engine not a performance tune.

[hoffmvn]

I attempted to fix your a/f ratio, smoothed out your low / high speed table a bit hope it does the charm for ya.

(Few things looked a little wonky to me but I am new to the tuning world.)

[swhangin]

Thank you very much hoffmvn, ill load it and hopefully that helps. Ive been trying to fix it the last couple days and its been getting a lot better. I wish I would have looked sooner. Here is the last kal I have where the start up wasn't too bad, still lean close to wot but drivability was a lot better

[swhangin]

The adjusted kal helped a lot but I still have a stumble upon start up. A few more adjustments and should be good.
This is an 06'-08' stock engine
custom cold air intake to fit the stock intake manifold
k20a2 exhaust manifold
no IACV